Motor trade insurance
Tyre fitter insurance covers liability for wheels and tyres you fit, damage to customers' vehicles, stock, equipment and, if you drive customer vehicles, road risks. A single wheel-loss accident can produce a large injury claim.
Part of: Motor trade insurance
In short
Tyre fitters, fixed or mobile, usually need public and products liability for wheel-loss and tyre failures, customer vehicles cover for damage while working, stock and tools cover, and road risks if they drive customer vehicles on the road. Employers' liability is compulsory once you employ staff. Record torque settings and re-torque advice: DVSA's roadworthiness guide refers to checking wheel nut torque after refitting. Part-worn sales must meet the 1994 tyre safety regulations, and tyres over 10 years old are banned on some commercial vehicle axles.
| Risk | Cover that commonly responds | Fixed depot | Mobile fitter |
|---|---|---|---|
| A wheel comes off after fitting and causes an accident | Public and products liability | Yes | Yes |
| Damage to a customer's vehicle while you work on it | Customer vehicles cover | On premises | At the customer's site or roadside |
| Driving customer vehicles on the road | Motor trade road risks | Moving cars in and out | Rarely, but check |
| Tyre stock, machines and tools | Stock, contents and tools cover | Premises, fire and theft | Kit and stock in the van |
| Injury to staff, including tyre bursts | Employers' liability | Yes, if you employ staff | Yes, if you employ staff |
Cover is subject to the insurer's acceptance and the policy terms. For the wider motor trade picture see motor trade insurance.
A wheel that detaches after fitting can injure people and damage other vehicles, so it is a public and products liability exposure rather than just a workmanship problem. Liability policies commonly respond to the injury and damage caused, subject to their terms, but often exclude the cost of redoing the work and replacing the parts you supplied.
For commercial vehicles, DVSA's guide to maintaining roadworthiness refers to the industry code of practice: after a wheel is removed and refitted, wheel nut torque should be checked, either after the vehicle has stood for 30 minutes or after it has travelled roughly 25 to 50 miles (40 to 80km), and re-torque checks must be recorded and kept on file. The guide also stresses checking the manufacturer's procedures. Whether or not a customer follows up, your records of torque settings and re-torque advice are the evidence you will rely on if a wheel-loss claim arrives.
Illustrative scenario: a mobile fitter replaces two tyres on a van. Three days later a wheel comes off on a dual carriageway and hits a car. The fitter's liability insurer will want the job card, torque settings and any re-torque advice given. If records are thin, the claim is harder to defend.
For consumer customers, the Consumer Rights Act 2015, section 49 requires services to be performed with reasonable care and skill.
Insurers commonly ask about part-worn sales and commercial vehicle work because both carry heavier liability. The main rules:
If you sell part-worn tyres or fit to commercial vehicles, tell your insurer. Under the Insurance Act 2015 duty of fair presentation, leaving out an activity can affect a claim.
HSE guidance on tyre removal, replacement and inflation says manual handling causes nearly half of tyre-related incidents and hand tools such as tyre levers about a quarter, while compressed-air accidents, from a burst tyre or wheel parts separating, are the most severe and can be fatal. HSE says a safety cage is not normally necessary for car tyres, but light commercial tyres at around 70psi may be enough to cause serious injury, and it advises enhanced measures for commercial tyres. It notes that a portable restraint may be useful for off-site repairs.
If you employ fitters, GOV.UK says employers' liability insurance with at least £5 million of cover is compulsory, with fines of £2,500 for each day you are not properly insured. Insurers commonly ask about training, inflation cages and whether you work on commercial or agricultural tyres.
Mobile fitters carry stock, a tyre machine, a balancer and a compressor in the van. Tools and stock in a vehicle are commonly covered subject to conditions for unattended vans and overnight parking, so check those before you rely on the cover. Your van itself may sit on a commercial vehicle policy or a motor trade policy.
If you move or test drive a customer's vehicle on a road, section 143 of the Road Traffic Act 1988 requires insurance covering that use; see road risks only motor trade insurance. Damage to the customer's vehicle while you work on it is usually a customer vehicles question, not public liability.
More: mobile mechanic insurance, garage insurance and the automotive trade broker guide.
Apex arranges motor trade insurance for garages and mechanics, including mobile mechanics, and road risks where you drive customers' vehicles. A broker reads your enquiry and comes back with options, and there is no fee for a quote. We need: what you fit (cars, vans, commercial, part-worn), your address and any depot, who drives (ages, licences, points), turnover, stock and equipment values, the typical value of customer vehicles, and your claims history. Cover is subject to the insurer's acceptance and the policy terms.
You may be, if the detachment is traced to your fitting. That is a public and products liability claim for the injury and damage caused. Liability policies commonly respond subject to their terms, so keep job cards, torque settings and records of re-torque advice to support your defence.
Yes, if they meet the Motor Vehicle Tyres (Safety) Regulations 1994. These include at least 2mm of tread across the full breadth and circumference and, for non-retreaded tyres, an approval mark with PART-WORN in letters at least 4mm high. Tell your insurer if you sell them.
It depends on whether you drive customers' vehicles on the road. If you do, the Road Traffic Act 1988 requires insurance for that use, and motor trade road risks is the usual route. You will still want liability, customer vehicles and tools and stock cover.
The Highway Code says cars, light vans and light trailers must have at least 1.6mm of tread across the central three-quarters of the tread and around the entire circumference. Motorcycles, large vehicles and passenger-carrying vehicles must have at least 1mm.
Yes, on certain axles. Since 1 February 2021, tyres aged over 10 years are not allowed on the front steered axles of lorries, buses and coaches, or on single wheels of minibuses with 9 to 16 passenger seats.
Tell us what your business does, who drives, your premises and vehicle values. A broker reads every enquiry and comes back with options. No fee for a quote. Or call 0117 325 0027.
Start a motor trade enquiry Request a callbackApex Insurance Brokers Limited is authorised and regulated by the Financial Conduct Authority. Registered in England and Wales, company number 07014570. This page is general information, not advice on your individual circumstances, and it does not guarantee that cover will be available or on what terms.